SKYDAS Premium Plius EI120

    SKYDAS PREMIUM PLIUS EI120 – is our top class security door. From now on they are also extremely fire resistant. They withstood 2 hours and 46 minutes burning in 1000^oC and were awarded fire resistant class EI 120. This was achieved without increasing the thickness of the door. -Burglar resistance tested and approved in Germany, prestigious Ift Rosenheim laboratory – RC4 (resistance class 4) by EN 1627:2011 standard; the testers tried to break this door continuously for 77 minutesusing various crowbars, hammering, cutting and drilling tools but were not able to break them! -At least one of the locks must be not lower than 7th security class; -The lock of 3 locking directions is additionally secured by drilling resistant plates; -Locks are installed in protection boxes; -Exceptional soundproofing (45 dB) -May be fire resistant EI45 / EI60 / EI90 / EI120; -May additionally be bullet resistant FB4. Tested in Germany by EN1522 standard; resistant to 9 mm bullets; -Made to measure; -Unlimited design possibilities, inswing or outswing; -Designed for the premises with very high risk of burglary both private and public; indoor and outdoor use (when using finishing made to withstand outdoor conditions).

Structural features of resistance: 1. The armoured lock is protected by 2 drilling resistant manganese plates. 2. The bodies of the main and additional locks are installed in protective steel boxes. 3. Higher security hinges have height adjustment mechanisms. 4. On the hinge side, there are eight 16mm diameter locking points. 5. On the lock side, there are six locking points and 2 additional points directed upwards and downwards. A separate protective sleeve secures each lock pin in the door frame. 6. The door leaf is of a combined structure: grating, steel sheet and grating again, so even if the outside grating was damaged, the door is still protected by the steel plate and inside grating. 7. Double thermal insulation: a 3 cm layer of rock wool on both sides of the steel sheet. It provides excellent noise and thermal insulation for the door. 8.The entire ultra strong structure of the door is covered by finishing board whose colour and design can be customized. 9. The lock pins are protected against damage not by steel sheet, but by a 15 mm thick bent profile. 10. The frame is fixed in the opening by 17 pins, protected by steel liners of 24 mm.

Certificates

  Note. All the parameters are valid for the doors with internal and external architraves.

Standard door set More about the features of the door Technical data

Standard door set: 1. Door frame – bent L-shaped profile of 115 mm, fixed in the door aperture by 17 plugs, protected from cutting by steel liners of 24 mm. Complete thermal insulation by rock wool or foam 2. Door leaf – special triple metal construction with 100% thermal insulation by two 30 mm rock wool sheets. Total width of the leaf is 91 mm. Has protective boxes of locks. 3. Reinforced, adjustable hinges with supporting bearings covered with chrome-plated finishing caps – 2 pieces. 4. Protective pins for door hinges (16 mm Ø) – 8 pieces. 5. Insulation seals – 2 pieces. 6. Outside and inside door leaf finish –  see here. 7.  Outside architraves. 8.  Locks – see the selection here (one of the locks must be no lower than 7th security class). 9. Both locks are installed in protective steel boxes. The armoured lock is protected by 2 drilling resistant manganese plates. 10. The lock rods of three directions are additionally protected by steel tubes.

Door characteristics

Safe  Specially bent L-shaped 115 mm wide door frame is not only wider than that of ordinary “armoured” door, but also has even 8 bending edges that reinforce the frame. The frame is fixed in the aperture by 17 plugs, which are protected from cutting by steel liners of 24 mm, thus there is no need to fix the door in concrete. Internal leaf construction is reinforced by rigid edges that do not allow deforming the door easily during burglary. At least one of the locks installed in this door model must be no lower than 7^th security class. The locks are installed in protective steel boxes. The armoured lock is protected by 2 drilling resistant manganese plates and each lock pin is protected by a separate protective sleeve in the door frame.

Excellent sound insulation and shutting out the odours  Due to full thermal insulation of the door structure by 60 mm rock wool, the sound insulation of the door SKYDAS PREMIUM PLIUS is even 45 dB. This door is especially tight and therefore, perfectly shuts out the odours and smoke from the outside.

Fire resistant EI120 During the test SKYDAS PREMIUM PLUS EI120 withstood the temperature of 1000ºC for as long as 2 hours and 46 minutes. This was achieved without increasing standard thickness of the door. Fire resistance is especially relevant in apartment buildings, where fire can spread from the neighbours or when the door is set on fire, and in private houses – from the boiler room or garage.

Durable and lasting, convenient to use All SKYDAS doors are manufactured by especially precise programmed machines Amada, which can process metal with the precision of 0.1 mm, therefore, their construction is precisely accurate and straight. As hinges with supporting bearings are used, the doors are easy to open and close, despite of heavier weight characteristic to metal doors. The tests in IF Rosenheim laboratory indicated that after 200,000 cycles of opening and closing, the construction of the door remained completely intact. As the internal construction of the door has no closed cavities, the entire metal construction is covered in powder coating, which ensures long-term surface protection from corrosion. The door finish is usually made of painted or PVC laminated MDF or Umidax-HLS board. Polyurethane paint is resistant to moisture, discolouring, cracking, and peeling; and PVC laminated MDF or Umidax-HLS board is especially resistant to scratching and chipping of corners. Under necessity, door finish can be easily replaced.

Simple to take care of Painted or PVC laminated door finish does not require any specific care and is easy to clean.

Design possibilities Choose a design from nearly 200 our finish carvings or we will manufacture a door according to an individual project prepared by an architect or us. The GALLERY for door photos.

Technical data

The door is manufactured precisely according to necessary measurements. Important: Burglar resistance certificate is applicable to single- leaf door measurements 2200 x 1000 mm, double door- 2200 x 1500 mm. The height and width of the door can be increased by 10% or reduced by 20%. Fire resistance EI45 of the fire resistant door is applicable to measurements up to 2230x 1010 mm.

Threshold Available thresholds (2 mm thick):

1. black metal,
2. RUUKKI galvanized steel,
3. matt stainless steel