Skydas standart

     sarvuotos durys 13If you want to enjoy warm, tight and safe armored door, SKYDAS STANDART is the right choice for you! Doors SKYDAS STANDART – excellent value for the money! -Reasonable security level; -Good soundproofing (41 dB Rw (C;Ctr)) and thermal transmittance (1,3 W/(m2K); -May be fire resistant (EI30, EI45) and smoke resistant (SM C5); -Made to measure; -Unlimited design possibilities, single, double, with side or upper panels; inswing or outswing; -Designed for the premises both private and public; indoor and outdoor use (when using finishing made to withstand outdoor conditions).

 

 

 

 

 

               

Certificates

sarvuotos durys standart 3 sertifikatas 2sertifikatas 11sertifikatas 12

 

Standard door set More about the features of the door Technical data

 

Note. All the parameters indicated in this table are valid for the doors with internal and external architraves.


Standard door set:

  1. Door frame – bent L-shaped profile fixed in the door aperture by 8 pins. Complete thermal insulation by rock wool or foam.
  2. Door leaf – special bent metal structure; 100% thermal insulation by 50 mm rock wool; total width of the leaf – 75 mm.
  3. Hinges with supporting bearings, covered with chrome-plated finishing caps – 2 pieces.
  4. Protective roll pins for door hinges (16 mm Ø) – 2 pieces.
  5. Insulation seals – 2 pieces.
  6. Peephole (14 Ø).
  7. Outside and inside door leaf finish – EDM or WRB board.
  8. Outside architraves.
  9. Locks – see the selection here.

Door characteristics

Šarvuotos durys 7 Saves the heat in your home As the bent profile leaf structure does not have closed cavities, it can be completely thermally insulated by 50 mm rock wool. The L-shaped bent frame and threshold ensure exclusive tightness as an additional seal is applied to the entire perimeter (two seals in total). Thermal transmittance of SKYDAS STANDART is 1.3 W/(m2–K), i.e. the same like of 6-chamber plastic windows (the lower the transmittance, the more heat is held in). Therefore, this door is suitable not only for an apartment, but also for a private house (using the materials suitable for outdoor conditions).

Šarvuotos durys 8 Tight, good heat and sound insulation   Due to the above mentioned full thermal insulation of the door construction, the sound insulation of the door SKYDAS STANDART is 41 dB. This door is especially tight and therefore, perfectly shuts out the odours and smoke from the outside.

Šarvuotos durys 1 Fire resistant With additional fire resistant components SKYDAS STANDART can protect from fire for as long as 45 minutes and withstand the temperature of 1000ºC. The certificate was issued by Inspecta Estonia OU, No. 1527-CPD-0017. The boiler room doors of private houses already have to meet fire protection requirements. The fire can also spread from the garage.

Šarvuotos durys 6 Durable and lasting, convenient to use All SKYDAS doors are manufactured by especially precise programmed machines Amada, which can process metal with the precision of 0.1 mm, therefore, their construction is precisely accurate and straight. As hinges with supporting bearings are used, the doors are easy to open and close, despite of heavier weight characteristic to metal doors. The tests indicated that after 100,000 cycles of opening and closing, the construction of the door remained completely intact. As the internal construction of the door has no closed cavities, the entire metal construction is covered in powder coating, which ensures long-term surface protection from corrosion. There are several options for the door finishing. Most commonly we use sustainably sourced EDM board (Extreme Durable MDF). It gives the freedom of design and is also water resistant, dimensionally stable and withstands severe atmospheric changes therefore is ideal for the finishing of entrance doors. For those who prefer wood-looking entrance door we offer – Water Resistant Board (WRB) made of natural hardwood veneers (okoume). This type of plywood is designed to withstand the most severe outside conditions. It‘s wood texture gives the luxury look to your door and does not limit your design ideas. Under necessity, door finish can be easily replaced. It is recommended to use galvanized steel RUUKKI for entrance door construction.

Šarvuotos durys 16 Simple to take care of Painted door finish does not require any specific care and is easy to clean with non-abrasive cleaners.

Šarvuotos durys 16 Available designs You can choose from almost 200 standard carvings or we will produce the doors according to individual design. Doors can be with the glazing of various shapes, single leaf, double leaf, with arch, etc. See GALLERY for doors photos. If you need warmer door designed specially for outdoors conditions, choose SKYDAS 2000. However, if higher security level is necessary, choose security doors SKYDAS STANDART 2, SKYDAS STANDART 3, or SKYDAS PREMIUM PLIUSwhich burglar resistance was tested and certified in an authoritative notified scientific research laboratory IFT Rosenheim, Germany. These door models were created applying the knowledge of the above mentioned laboratory of all possible ways and methods of burglary.


Technical data

Galimi durų variantai

SKYDAS 2000 section

SKYDAS pjuvis standart

Thresholds:

Available thresholds (2 mm thick):

  1. black metal,
  2. RUUKKI galvanized steel,
  3. matt stainless steel:

 

 slenkstis SKYDAS standart

Item photo Description
  Handle ASSA 6638, with spring. Finishing: Chrome Mat chrome Other- on request
  Handle ASSA 1956, with spring Finishing: Chrome Mat chrome Other- on request
Handle ASSA 6647 Finishing: Chrome Mat chrome Other- on request
Fixed handle ASSA 496 Finishing: Chrome Mat chrome Other- on request
Handle Y96, with spring Finishing: Chrome Mat chrome
Handle ASSA YALE A6647, with spring. Finishing: Chrome Mat chrome

Handle K27, with spring Finishing: Chrome Mat chromeMat stainless steel handle up to 1m. (stainless steel decoration of the door leaf is not included)Mat stainless steel handle up to 2m.Cable shell (for electromechanical locks)ASSA case plateMottura drill resistive lock plate (to protect the lock from drilling). Suitable for locks: Mottura, Fiam and Mul-T-Lock CFMA.Stainless steel decoration up to 0,3m2 of the door leaf (handle is not included)Stainless steel decoration up to 0,3m2 at the bottom of the door leaf.3D milling up to 0,3m2Ventilation gridDoor closer ASSA D15 (for the door up to 85 kg) Door closer ASSA D35 (for the door up to 120 kg) Extra prolonged rings into case (for safe type lock for the doors Skydas 2000) Glossy brass plastic hinge covers Glossy chrome plastic hinge covers Mat stainless steel hinge covers Electric bolt Down sliding door seal The peak to protect from rain  (for the interior-opening doors) Sloping threshold 15x100x20 mm Door leaf laminated with 2 PVC colours up to 0,2m23-pins additional locking mechanism MOTTURA 96087IAlarm sensor at the top of the casing

Without inner opening decoration With inner opening decoration  Interior opening decoration

Other accessories: All metal construction made of electro-galvanized steel RUUKKI (for the door to be used in the outdoor conditions). All metal construction made of mat stainless steel. All metal construction made of glossy stainless steel. Glazing of various shapes.

Metal door construction is given the warranty of 5 years. The colour coating of the metal door construction for using under interior conditions is given the warranty of 3 years. The colour coating of the galvanized metal door construction for using under outdoor conditions is given the warranty of 2 years. Door finish:

  • MDF board, laminated by PVC film (interior conditions) – 3 years.
  • Umidax HLS board, painted (outside and inside) – 1 year.
  • Umidax HLS board, laminated by PVC film (without milling) under outdoor conditions, for the outside of the door – 1 year.
  • Umidax HLS board, laminated by PVC film (without milling) under outdoor conditions, for the inside of the door – 1 year.
  • Solid wood and natural veneer are available on request. Under interior conditios warranty 3 years. Under outside conditions –  not given the warranty.

Locks – manufacturer’s guarantee (see LOCKS). Peepholes, handles, seals, lock finish parts are not given a warranty.