SKYDAS Standart

        sarvuotos durys 28

 

If you want to enjoy warm, tight and safe armored door, SKYDAS STANDART is the right choice for you!
Doors SKYDAS STANDART – excellent value for the money!

-reasonable security level;

-good soundproofing (41 dB Rw (C;Ctr)) and thermal transmittance (1,3 W/(m2K);

-may be fire resistant (EI30, EI45) and smoke resistant (SM C5);

-made to measure;

-unlimited design possibilities, single, double, with side or upper panels; inswing or outswing;

-designed for the premises both private and public; indoor and outdoor use (when using finishing made to withstand outdoor conditions).

 

 

 

 

 

 

 

 

 

Certificates

sarvuotos durys standart 3 sertifikatas 2sertifikatas 11 sertifikatas 12

 

 

 

 

 

Standard door set

More about the features of the door

Technical data

 


Note. All the parameters indicated in this table are valid for the doors with internal and external architraves.


Standard door set:

  1. Door frame – bent L-shaped profile fixed in the door aperture by 8 pins. Complete thermal insulation by rock wool or foam.
  2. Door leaf – special bent metal structure; 100% thermal insulation by 50 mm rock wool; total width of the leaf – 75 mm.
  3. Hinges with supporting bearings, covered with chrome-plated finishing caps – 2 pieces.
  4. Protective roll pins for door hinges (16 mm Ø) – 2 pieces.
  5. Insulation seals – 2 pieces.
  6. Peephole (14 Ø).
  7. Outside and inside door leaf finish – see the selection here.
  8. Outside architraves.
  9. Locks – see the selection here.

Door characteristics

Šarvuotos durys 7 Saves the heat in your home

As the bent profile leaf structure does not have closed cavities, it can be completely thermally insulated by 50 mm rock wool. The L-shaped bent frame and threshold ensure exclusive tightness as an additional seal is applied to the entire perimeter (two seals in total).

Thermal transmittance of SKYDAS STANDART is 1.3 W/(m2K), i.e. the same like of 6-chamber plastic windows (the lower the transmittance, the more heat is held in). Therefore, this door is suitable not only for an apartment, but also for a private house (using the materials suitable for outdoor conditions).

Šarvuotos durys 8 Good sound insulation and shutting out the odours Due to the above mentioned full thermal insulation of the door construction, the sound insulation of the door SKYDAS STANDART is 41 dB.
This door is especially tight and therefore, perfectly shuts out the odours and smoke from the outside.

Šarvuotos durys 1 Fire resistant With additional fire resistant components SKYDAS STANDART can protect from fire for as long as 45 minutes and withstand the temperature of 1000ºC. The certificate was issued by Inspecta Estonia OU, No. 1527-CPD-0017. It is especially relevant in apartment buildings, where fire can spread from the neighbours or when the door is set on fire, and in private houses – from the boiler room or garage.

Šarvuotos durys 6 Durable and lasting, convenient to use

All SKYDAS doors are manufactured by especially precise programmed machines Amada, which can process metal with the precision of 0.1 mm, therefore, their construction is precisely accurate and straight. As hinges with supporting bearings are used, the doors are easy to open and close, despite of heavier weight characteristic to metal doors. The tests indicated that after 100,000 cycles of opening and closing, the construction of the door remained completely intact.

As the internal construction of the door has no closed cavities, the entire metal construction is covered in powder coating, which ensures long-term surface protection from corrosion.
The door finish is usually made of painted or PVC laminated MDF or Umidax-HLS board. Polyurethane paint is resistant to moisture, discolouring, cracking, and peeling; and PVC laminated MDF or Umidax-HLS board is especially resistant to scratching and chipping of corners.
Under necessity, door finish can be easily replaced.

Šarvuotos durys 16 Simple to take care of Painted or PVC laminated door finish does not require any specific care and is easy to clean.

 

Šarvuotos durys 16 Design possibilities

Choose a design from nearly 200 our finish carvings or we will manufacture a door according to an individual project prepared by an architect or us.

The door can be single, double, arched, with a fanlight, etc. See GALLERY for door photos.

Šarvuotos durys 10 Safe

Specially bent L-shaped door frame has 6 bending edges and thus is stronger than rectangular or tube frame, which have only 4 bending edges.

Internal leaf construction is reinforced by rigid edges that do not allow deforming the door easily in case of burglary.

On the hinges side there are 2 roll pins (16 mm Ø) that do not allow dislodging the door leaf if the hinges are cut. These protective pins roll on bearings and therefore are difficult to cut.

If reliable locks are used, this door will not only save the heat at home, but also protect from the noise and unwanted visitors.

However, if higher security level is necessary, choose security doors SKYDAS STANDART 2SKYDAS STANDART 3, or SKYDAS PREMIUM PLIUSwhich burglar resistance was tested and certified in an authoritative notified scientific research laboratory IFT Rosenheim, Germany. These door models were created applying the knowledge of the above mentioned laboratory of all possible ways and methods of burglary.


Technical data

sarvuotos durys 14

The door is manufactured precisely according to necessary measurements.

Fire resistance EI45 of the fire resistant door is applicable to measurements up to 2100x 980 mm. If the height or width is increased by 15% (but not more than 20% of the total area), fire resistance will be EI30.

SKYDAS STANDART

sarvuotos durys 31 skydas standart

Threshold

Available thresholds (2 mm thick):

  1. black metal,
  2. RUUKKI galvanized steel,
  3. matt stainless steel.

sarvuotos durys 30 slenkstis


 

 

 

 

 

Item photo Description
  Handle ASSA 6638, with spring.
Finishing:
Chrome
Mat chrome
Other- on request
  Handle ASSA 1956, with spring
Finishing:
Chrome
Mat chrome
Other- on request
Handle ASSA 6647
Finishing:
Chrome
Mat chrome
Other- on request
Fixed handle ASSA 496
Finishing:
Chrome
Mat chrome
Other- on request
Handle Y96, with spring
Finishing:
Chrome
Mat chrome
Handle ASSA YALE A6647, with spring.
Finishing:
Chrome
Mat chrome
Handle K27, with spring
Finishing:
Chrome
Mat chrome
Mat stainless steel handle up to 1m. (stainless steel decoration of the door leaf is not included)
Mat stainless steel handle up to 2m.
Cable shell (for electromechanical locks)
ASSA case plate
Mottura drill resistive lock plate (to protect the lock from drilling). Suitable for locks: Mottura, Fiam and Mul-T-Lock CFMA.
Stainless steel decoration up to 0,3m2 of the door leaf (handle is not included)
Stainless steel decoration up to 0,3m2 at the bottom of the door leaf.
3D milling up to 0,3m2
Ventilation grid
Door closer ASSA D15
(for the door up to 85 kg)
  Door closer ASSA D35
(for the door up to 120 kg)
  Extra prolonged rings into case (for safe type lock for the doors Skydas 2000)
  Glossy brass plastic hinge covers
  Glossy chrome plastic hinge covers
  Mat stainless steel hinge covers
  Electric bolt
  Down sliding door seal
The peak to protect from rain  (for the interior-opening doors)

Sloping threshold 15x100x20 mm

Door leaf laminated with 2 PVC colours up to 0,2m2
3-pins additional locking mechanism MOTTURA 96087I
Alarm sensor at the top of the casing
Without inner opening decoration

With inner opening decoration

 

 Interior opening decoration

Other accessories:
All metal construction made of electro-galvanized steel RUUKKI (for the door to be used in the outdoor conditions).
All metal construction made of mat stainless steel.
All metal construction made of glossy stainless steel.
Glazing of various shapes.

Metal door construction is given the warranty of 5 years.

The colour coating of the metal door construction for using under interior conditions is given the warranty of 3 years.

The colour coating of the galvanized metal door construction for using under outdoor conditions is given the warranty of 2 years.

Door finish:

  • MDF board, laminated by PVC film (interior conditions) – 3 years.
  • Umidax HLS board, painted (outside and inside) – 1 year.
  • Umidax HLS board, laminated by PVC film (without milling) under outdoor conditions, for the outside of the door – 1 year.
  • Umidax HLS board, laminated by PVC film (without milling) under outdoor conditions, for the inside of the door – 1 year.
  • Solid wood and natural veneer are available on request. Under interior conditios warranty 3 years. Under outside conditions –  not given the warranty.

Locks – manufacturer’s guarantee (see LOCKS).

Peepholes, handles, seals, lock finish parts are not given a warranty.